Convair ClimateMaster CM12RCS, Инструкция по эксплуатации

Страница: 9 / 16

12
13
Starting the air conditioner
Step 1: Ensure the cooler is plugged in and
switched on.
Step 2:
Step 3:
Step 4:
!
Step 5:
!
Press the ON/OFF button on the
remote control or ON/OFF button on the
control panel to start the air conditioner.
Press the MODE button on the
control panel or MODE button on the
remote control to select the desired
operating mode (Fig. 11):
Press / on the control panel
or on the remote control to select the
desired temperature.
Do not set the cooling temperature too
low. This will consume more power. 24°C is
the recommended set temperature, with
high fan speed.
Changing the set temperature will
have no effect in FAN or DRY modes.
Press the SPEED button on the
control panel or the remote control to adjust
the fan speed. Each press will cycle the fan
speed as below:
Low speed
Medium speed
High speed
In Dry mode, the fan will always be
set to low speed. In heating and cooling
modes, the fan may automatically change
to high speed to protect the refrigeration
system.
In Cooling mode, the fan will continue
to run even when the compressor has
cycled off.
Auto mode
Heating mode
Fan mode
Cooling mode
Dry mode
- automatic selection of
operating mode
- reverse cycle heating
- Fan only operation (no
cooling)
- refrigerated cooling
- refrigerated moisture
removal from the air
r s
The temperature set range is 16°C-31°C
Tip
Note!
Note
Note!
Step 6:
Do not attempt to move the
motorised vanes by hand !
Important !
The air conditioner has 2 sets of
motorised air direction vanes. Press
the OSC buttons on the control panel or the
remote control to turn the vanes on or off.
operates the horizontal vanes - air
will sweep from side to side (Fig 12)
operates the vertical vanes - air will
sweep up and down (Fig 13)
Press the buttons again to stop the sweeping
vanes.
The cooler will store the last mode
selected in memory and return to this when
next switched on.
During cooling and heating
mode, water will collect in the air
conditioner’s tank.
In cooling mode this
water is recirculated and some will be
exhausted out with the hot air, but will slowly
fill up the tank. This occurs more quickly in
humid conditions. In heating mode there is
no recirculation. If the tank should fill, error
code “E2” will appear on the control panel,
the unit will ‘beep’ 10 times and then shut
down. Refer to the Maintenance section for
draining the tank should this occur.
Note!
Step.2
Step.5
Step.3
Step.4
Step.6
11
OSC
Mode Temp Speed
On / Off Timer
OSC
OSC
OSC
OPERATION
7