Convair CEH01R, Инструкция пользователя

Страница: 5 / 8

OPERATION
MAINTENANCE
SAFETY DEVICES
To maximise the efficiency of the heater,
clean the inlet and outlet grilles regularly.
• Unplug the heater from the mains power
supply before cleaning.
• Use a soft, damp cloth to wipe the
outside.
• Use a vacuum cleaner to remove dirt and
dust from the inlet and outlet grilles.
• Ensure the heater is dry before plugging
back into the mains power supply.
To avoid overheating problems the in built
safety device will interrupt electricity if the
heating elements become too hot.
If this should happen:
• Take the plug out of the mains socket.
• Let the heater cool down for 10 minutes.
• Check that the heater is positioned
correctly.
• See that there is no dust or other
obstacles hindering the air flow.
• Clean the inlet & outlet grilles if necessary.
The heater is also equipped with a ‘tip-over’
switch, which will turn off power to the heater
elements if it should fall over.
,
I
0
II
Ý
5b
5a
3
OPERATION
The Convair fan heater is excellent in
providing spot heating throughout your
home.
It should not be considered as a
centralized heating unit for your whole
house.
The fan heater is fitted with both a heat
setting controller ( Fig 5a) and a thermostat
controller (Fig 5b).
To begin using your heater, select the
desired setting from the Heat Setting Control
(5a)
0
= OFF (both the fan and heat
element)
I = Low Heat (1000 W)
II = High Heat (2000 W)
The Thermostat Control (5b) will turn the
heater on / off as the room temperature
changes.
= set to highest room temperature
• = set to lowest room temperature
= defrost setting (below 5°C)
Ý
As the policy of this company is one of continuous improvement, all specifications are subject to change without notice.
Waste electrical products must not be disposed of with household waste. This
product should be taken to your local recycling centre for safe treatment.