87
GB
LEK
90
°
Lay the metal fitting plate in place on top of the
chimney frame. Adjust the supporting structure
and the chimney frame with the adjusting nuts by
following the instructions on page 84.
Medium high model with flue height 1775 mm.
Fold in the metal tabs in the middle of the chimney frame.
LEK
LEK
Put the sealing plate and block of insulating material in place.
Poke the corners of the insulating block out through the holes
in the corners of the chimney frame. Check to make sure that
the insulation forms a tight seal with the chimney frame: this is
important to prevent hot convection currents from rising up to
the ceiling.
LEK
LEK
LEK
Gäller ej!
Fit the flue sleeve by following the instructions on page 85.
To determine the right height for the hole in the wall, hold the
connecting flue in place against the stove. Adjust the length
of the connecting flue and push it into place in the flue sleeve.
Seal the joint between the sleeve and the connecting flue with
sealing rope.
LEK
Cut away the partly punched cover
on the rear panel and hang the
panel over the connecting flue.
Check to ensure that the stove
body is standing straight
and perpendicular. Slide the
connecting flue over the collar.
Make sure that the seal round the
collar is not dislodged. If further
sealing material is required, heat-
resistant sealant may be used.