ELECTRIC CONNECTIONS
Remove the cover screw with a screwdriver and then remove the
cover as shown in the picture beside.
The actuator is equipped with a 8 poles removable terminal block;
the each pole of the plug is clearly marked and the same label are
reported on the electronic board. Before powering up the actuator
make sure the plug is properly connected to the board and the label
on the plugs and on the board match.
Use PG13,5 cable gland (not supplied).
Linkage
MVE
MVES
Current Controlli valves
(except for 2TGB.F/3TGB.F PN16)
(not required)
/
2TGB.F/3TGB.F PN16
/
(not required)
Controlli valves with threaded M40
connections
(except for VSB/VMB/VSBF/VMBF
PN16)
AG51
/
VSB/VMB/ VSBF/VMBF PN16
AG52
AG63
Other manufacturers
Landis *
AG70-10
AG70-14
/
Danfoss (VR/VF (S) models)
AG60-07
/
TAC DN15-V298
AG 60-08
/
TAC DN15-V2XX/V3XX
AG 60-09
/
Honeywell**
AG 60-10
/
Airtek
AG 60-11/
AG60-12
/
Johnson Controls code VB7816-
2111
AG 66
/
Johnson Controls code BM-3018-
3300
AG 67
/
Tac Venta
(not required)
/
(/) this model can not be assembled
(*) AG70-10 for valves having stem Ø 10mm
AG70-14 for valves having stem Ø 14mm
(**) valid for the following models: M6: V176A. B, V538C
1/4”: V5011A
ASSEMBLING
The actuator can be mounted with any orientation but never up-side
down. When the fluid temperature exceed 120°C the actuator shall
be mounted leaning 45°.
N4170-17
T fluid ≥ 120°C
T fluid MAX 120°C
T fluid ≥ 120°C
To mount the actuator on to a valve, position the valve stem to the
bottom of its travel, slide the actuator onto the valve neck, adjusting
with the manual override the screw jack position so the square nut
on the valve spindle fits into the groove on the cross bar. Then slide
the brace into the groove on the valve neck and secure the nuts.
See mounting instructions for full details (MVE_DIM223).
MAINTENANCE
The actuator is free of maintenance.
ACCESSORIES
DMVE
End point auxiliary switches (electrical rate 24V AC/DC,
4A max)
248
Yoke heater (suggested when the fluid temperature is be-
low 0°C)
GMVE
Thermal insulation for MVE actuators
GMVE.S
Thermal insulation for MVE.S actuators
1
st
Issue rev. a
04/2016
DBL483e
Page 3
