Traceable
®
is a registered trademark of Control Company
©
2008 Control Company. 92-4381-00 Rev. 2 052308
PRECAUTIONS
●
Do not immerse the unit in water.
●
Do not clean the unit with abrasive or corrosive materials. They may scratch the
plastic parts and corrode the electronic circuit.
●
Do not subject the unit to excessive force, shock, dust, temperature, or humidity,
which may result in malfunction, shorter electronic life span, damaged battery
and distorted parts.
●
Do not tamper with the units internal components. Doing so will invalidate the
warranty on the unit and may cause unnecessary damage. The unit contains no
user-serviceable pans.
●
Only use fresh batteries as specified in the user’s manual. Do not mix new and
old batteries as the old ones may leak.
NOTE ON COMPLIANCE
This product complies to standards and specifications of FCC and article number 334
of P11.
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the users authority to operate the equipment.
NOTE:
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
●
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can he determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that which the
receiver is needed.
CAUTION
●
The content of this manual is subject to change without further notice.
●
Due to printing limitation, the displays shown in this manual may differ from the
actual display.
●
The manufacturer and its suppliers held no responsibility to you or any other
person for any damage expenses, lost profits, or any other claim arise by using
this product.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-
Certified by DNV and ISO 17025 accredited
as a Calibration Laboratory by A2LA.
