Traceable
®
is a registered trademark of Control Company
©
2008 Control Company. 92-4110-00 Rev. 2 051908
2.
While in Timer mode, press the HR button to advance Hour setting.
3.
Press the MIN button to advance Minute setting.
4.
Begin countdown by pressing the START/STOP button.
5.
Stop countdown by pressing the START/STOP button.
6.
Press any key to silence the sounding alarm or it will alarm for 1 minute before
silencing.
7.
Reset timer to 00 hours, 00 minutes by holding down the ON button while in
Timer mode.
ALL OPERATIONAL DIFFICULTIES
If this unit does not function properly for any reason, please replace the battery with a
new, high-quality battery (see “Battery Replacement” section). Low battery power can
occasionally cause any number of “apparent” operational difficulties. Replacing the
battery with a new fresh battery will solve most difficulties.
BATTERY REPLACEMENT
An erratic display, faint display, no display, or “BATT” appearing on the display are all
indicators that the battery needs replacement. This unit uses one piece UM-4 or AAA
size battery (1.5 DC).
1. Unscrew the five screws located on back of unit and remove cover (see Figure 2).
2. Insert new battery and be sure battery is replaced as indicated by the polarity
symbols (+ and -) marked inside the battery compartment.
3. Replace back cover and screws.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-
Certified by DNV and ISO 17025 accredited
as a Calibration Laboratory by A2LA.
