2
FIGURE 1
Reprogramming instructions.
Please follow these steps:
1. Power up the base unit and remove the cover of the base unit with a small Phillips screw driver.
2. On the back side of the keychain remote depress the ADD button with a paperclip and release.(If
working properly a blue light in the window will blink. Note on some models the blue light will be
located on the front of the transmitter.).
3. Flip the keychain remote over and push each button individually to send address to the base unit.
THEN WAIT UNTIL THE BLUE LIGHT STOPS BLINKING AND PROCEED.
4. Go to the base unit and push the black button. The red LED will begin to flash.
5. Again push each button on the keychain remote to save the unique address (1 in 16 million)
6. Push black button on the base unit to end the programming mode and the red LED will stop flashing.
YOUR UNIT IS NOW READY TO USE.
BATTERY REPLACEMENT
The Keychain remote uses a standard CR2032 Lithium button cell battery. In normal use it will provide 1-
2 years of operation. To replace the battery, gently pry apart the 2 halves of the remote.
Remove the battery by sliding it out from underneath the retainer. Observe the battery polarity when
replacing. Once the battery is replaced,
YOU NEED TO REPROGRAM THE KEYCHAIN TO THE
BASE UNIT
(A) Button
(B) Button
(C) Key Chain hole
