Wiring diagrams
For bus wiring details, refer to the
Keypad Bus Wiring Guide
(
ctrl4.co/buswiring
).
Operation and configuration
On initial power up, all status LEDs on the keypad will illuminate green, indicating
that the device has power. Until the keypad has been configured into a Control4
system, it will not control any loads. To set up this keypad for use with a Control4
system, refer to the
Composer Pro User Guide
(
ctrl4.co/cpro-ug
).
Button tap sequences
The button tap sequences are defined in the table below. Button tap sequences
that require a single button should use the top-most button installed on the
keypad. Button tap sequences requiring two buttons should use the top-most and
bottom-most (or bottom-left) buttons installed on the keypad.
Function
Button sequence
Identify
4
Reboot
15
Factory reset
9-4-9
Unidentify
13-4-13
Troubleshooting
If the LEDs do not light up indicating that the keypad is receiving power:
•
Ensure that the Bus Power Supply is powered on.
•
Ensure that the Bus Ethernet Gateway is powered on and connected.
•
Check for proper wiring (see “Installation instructions” above).
•
For help on the installation or operation of this product, email or call the
Control4 Technical Support Center. Provide your exact model number. Contact
[email protected] or see
www.control4.com
.
Care and cleaning
• Do
not
paint the keypad or its wall plate.
• Do
not
use any chemical cleaners to clean the keypad.
•
Clean surface of the keypad with a soft damp cloth as needed.
Regulatory/safety information
Find details of the product’s Limited Warranty at
snapav.com/warranty
or request a paper copy from Customer Service at
866.424.4489
.
Find other legal resources, such as regulatory notices and patent
information, at
snapav.com/legal
.
Copyright ©2021, Wirepath Home Systems, LLC. All rights reserved. Control4 and SnapAV and
their respective logos are registered trademarks or trademarks of Wirepath Home Systems, LLC,
dba “Control4” and/or dba “SnapAV” in the United States and/or other countries. 4Store, 4Sight,
Control4 My Home, Snap AV, Araknis Networks, BakPak, Binary, Dragonfly, Episode, Luma,
Mockupancy, Nearus, NEEO, Optiview, OvrC, Pakedge, Sense, Strong, Strong Evolve, Strong
Versabox, SunBriteDS, SunBriteTV, Triad, Truvision, Visualint, WattBox, Wirepath, and Wirepath
ONE are also registered trademarks or trademarks of Wirepath Home Systems, LLC. Other
names and brands may be claimed as the property of their respective owners. All specifications
subject to change without notice.
200-00346-E 20210409MS
