rectangular enclosure and one ferrite (1) clamp with a
round enclosure.
Ferrite Clamp Installation when Using Power over
Ethernet (PoE)
When powering the 5” or 7” In-Wall Touch Screen
using PoE, install the two (2) rectangular ferrite
clamps on the Ethernet cable behind the wall box as
shown next.
Ferrite Clamp Installation when Using AC Power and
a WiFi Network Connection
When powering the Touch Screen using 110 or 240
VAC, install the round ferrite clamp on the AC cable
behind the wall box as shown below.
• Plastic box
: Slide the wall plate toward the back
of the wall box.
• Metal box
: Inscrew the wall box from the stud
plate.
This allows you to attach the stud plate to the wall
stud without interference from the wall box.
4
Align the stud plate with the marks you made on
the stud (Step 2). If you are using a plastic unit,
make sure the dovetail is toward the back of the
stud plate (away from you).
5
Nail or screw the stud plate to the wall stud.
6
Mount the wall box to the stud plate.
• Plastic box
: Slide the wall box onto the stud
plate dovetail all the way, leaving the wall box
protruding the depth of the drywall, or slightly
less (Step 2a).
• Metal box
: bolt the wall box back onto the stud
plate.
Note:
If you are using a metal box, you can
continue to adjust its angle and position
slightly relative to the drywall.
7
Install the drywall according to the normal
procedures, making sure to cut the size of the
hole accurately.
8
After you install the drywall, carefully tighten the
screws to pull in the securing tabs so that the
wall box is flush with the surface of the wall.
Note:
Overtightening the screws may pull the
box into the wall.
IMPORTANT!
When you are ready to install
the drywall, and you are cutting the opening
for the wall box,
DO NOT
cut the opening too
large. Be conservative and enlarge the hole as
needed, because there isn’t as much overhang
on the faceplate of the Touch Screen as you
are accustomed to using with standard switch
and outlet plates.
Ferrite Clamp Installation
When installing the Control4® 5” or 7” In-Wall Touch
Screen, also install the enclosed ferrite clamps (see
next figure) as described in this document. The wall
box packaging includes two (2) ferrite clamps with a
Rectangular
Ferrite Clamps
Round
Ferrite Clamp
