Before You Install in a Third-Party DIN Rail Panel
1
Install the third-party panel according to the third-party instructions.
Installation Instructions
Install in a Control4 Panel
1
With the Ethernet port facing right, hold the Bus Ethernet Gateway upright
and angle it to the right so that the right side of the module fits onto the rail
in the panel.
2
With the right side already in place, push forward on the left side of the Bus
Ethernet Gateway to snap it onto the rail (see Figure 2).
Figure 2. Snap on the Bus Ethernet Gateway - Control4 Panels
NOTE
:
To remove the module, push the module toward the left side, pull
out from the left side., and remove it from the right side.
Install in a Third-Party Panel
1
With the Ethernet port facing up, hold the module lengthwise and angle it up
so that the top side of the module fits onto the rail.
2
With the top side already in place, rotate the module down to snap it onto the
rail (see Figure 3).
Figure 3. Snap on the Bus Ethernet Gateway - Third-Party Panels
NOTE
:
To remove the module, push the module toward the bottom, rotate
the module up, and lift it off.
3
On the top of the Bus Ethernet Gateway, connect the Ethernet CAT5 cable to
the RJ-45 port.
4
Install the other modules in the panel as defined in their respective installation
guides.
Wiring Diagrams
For information about bus wiring details, refer to the
Keypad Bus Wiring Guide
.
Operations and Configuration
Button Taps
The button taps are defined in the table below.
Function
Button Taps
Identify
4
Factory Reset
9
Reboot
15
LED Indicators
The indicator lights on the front of the Bus Ethernet Gateway communicate the
status of the device.
Indicator
Color
Status
Notes
Status
Blue
Power On
Black
No Power
Link/Activity
Solid Green
Link
Orange
Activity
Flashing Green
Firmware is updating
Flashing gets faster
as the
update proceeds
Reset Button
NOTE:
The Reset button is recessed and must be pressed using a paper
clip or similar device. A single click of the
Reset
button is equivalent to
powering the Bus Ethernet Gateway off and back on.
Regulatory/Safety Compliance
To review regulatory information for your particular Control4 products, see
the information located on the Control4 website at: http://www.control4.com/
regulatory/.
Warranty
For complete warranty information, including details on consumer legal rights as
well as warranty exclusions, review the Warranty card or visit www.control4.com/
warranty.
About this Document
Part Number: 200-00345 Rev. B 7/26/2013 BN
Copyright ©2013 Control4. All rights reserved. Control4, the Control4 logo, the Control4 iQ logo and the Control4 certified logo are registered trademarks or trademarks of Control4 Corporation in
the United States and/or other countries. All other names and brands may be claimed as the property of their respective owners Pricing and specifications are subject to change without notice
