Contracor 10130840, Инструкция по эксплуатации

Страница: 8 / 36

CONTRACOR
®
Version 2.0 8
2.1. Prior to use.
Ensure that the compressor is switched on and that it has been set to the correct
operat¬ing pressure. Check that the compressor is regularly inspected and maintained.
A worn and/or dirty compressor supplies polluted air that will not be cleaned by the filter
system! Make sure that the compressor cannot suck in any dangerous matter via the air inlet.
Adjust the operating pressure on the BAF airline filter to a minimum of 4.5 bar. Connect
the Contracor CCT Air Conditioner via the BAH breathing air supply hose to the BAF airline
filter system.
Make sure that the Contracor CCT Air Conditioner is correctly secured to the belt, that
the helmet connection of the hose for the breathing air is not leaking, and that the hose
is sufficiently secured against inadvertent release. Refer to paragraph “Maintenance and
inspection”. Continue with a test run of at least 3 minutes when using the equipment for
the first time.
2.2. During use.
Adjust the air volume according to requirements. The desired temperature of the
breathing air is reached within a short time. The air flow indicator in the blast helmet will
warn the user if insufficient air is supplied. Immediately leave the working area if there is an
interruption in the air supply.
Ensure that the breathing air supply hose cannot be trapped, causing interference
with the air supply or preventing a rapid departure from the work area. The Contracor CCT
Air Conditioner does not reduce the environmental noises. The use of supplementary audio
protection is mandatory. It is quite normal that a certain amount of air escapes from the
unused air outlet.
2.3. After use.
After leaving the working environment, disconnect the breathing air supply hose,
release the belt and remove the blast helmet. Clean and inspect the components according
to the instructions given in paragraphs «Cleaning and disinfecting» and «Maintenance and