Clip the stabiliser bar on to
“PANEL A”
Mark the fixing point on the wall around the wall lug.
Unscrew the wall lug from the stabiliser bar with an allen key and use
it to mark the centre point for the wall fixing. Drill a hole with a suit-
able drill bit and insert suitable wall fixings. (
NOT SUPPLIED
).
14: 45º STABILISER BAR
Drill the
“PANEL A”
compensators with a 3mm
drill bit through the pre-drilled 4.5mm hole on the
compensator located on the inside face (inside of
the shower area).
Using the screws supplied in
Pack “A”
securely fix both
panels to the wall compensators and conceal using the
supplied chrome cover caps .
VIEW FROM INSIDE SHOWER AREA
Take the wall lug from the stabiliser bar and using suitable wall
fixings (
NOT SUPPLIED
) screw securely to the wall,
as shown
above
.
Re-attach the stabiliser bar to the wall lug &
“PANEL A”
as
shown in Step 14.
Silicone joint between floor / shower tray both
“PANEL A’s”
.
Allow suitable cure time for silicone (this may be 24 hours
depending on the variety used).
FOLLOW THE MANUFACTURERS GUIDELINES WHEN
USING SILICONE SEALANT.
13: DRILL COMPENSATOR
15: FIX STABILISER BAR
Measure from the wall to the front inside edge of
PANEL “A”
compensator,
see above left
. Using your measurement, measure
from the front shoulder of the top cap back to the ribbed area of
the top cap and mark,
see above right
.
Cut of the excess ribbed area with a small hacksaw.
The cut end of the cap should fit against the wall,
see inset above
.
16: CUT TOP CAP TO SIZE
Place the bracket of the latch against the leading edge of
PANEL “B”
(Next to
PANEL “C”
). Using a 4mm allen key
tighten the grubscrews,
do not overtighten
.
OPTIONAL LATCH
17: SEAL WITH SILICONE
TIP:
On the outside of the panel silicone along the compensator
and the glass. On the inside silicone along the
glass only
.
B
C
Contour Showers, Siddorn Street, Winsford, Cheshire CW7 2BA
Telephone: 01606 592586 Fax: 01606 861260
Email: [email protected]
Website: www.contour-showers.co.uk
built-in independence
You have now assembled one section of your door.
REPEAT STEP FOR THE RETURN PANEL OR INLINE DOOR
