Standard Fitting Guide.
1)
Lift off door and lay aside.
2)
Fit the wall fixing brackets to timber frame under back rim for fixing the bath to the wall.
3)
Drill and affix Taps.
4)
Fit wastes, overflow and shallow waste traps supplied.
5)
Place bath in position and adjust to it’s minimum height.
Note: It is advisable to fix batten runs on to the floor under the bath feet to avoid
extending the legs to far & to ensure feet sit squarely and flat. On a wooden floor batten
runs (3” x 2” minimum) should be positioned squarely across the floor boards to spread &
support the load.
6)
Level bath in all planes using the four adjustable feet on the four outer corners and lock the
feet.
7)
Mark wall fixings and plumbing runs.
8)
Remove bath, drill wall fixings and run plumbing into position.
9)
Re-position bath and affix to wall and to floor via all four bath feet.
10) Connect plumbing. The wastes may be run independently or joined by use of a tee. Refer to
fitting guides for the Thermostatic valve and Pump if supplied.
11) Re-hang door.
12) Test plumbing for leaks.
13) Fill bath to maximum and leave for about 30 minutes to test the door seal.
14) While the bath seal is tested position and trim to size Front and Side.
15) Mark bottom of panels onto floor base. Fix battens along floor behind panels.
16) Refit front and side panels. Drill through bottom into batten and top into bath wooden frame.
Affix panels using screws and caps. Do not use Silicone sealant as this prevents service access.
17) Finally drain bath and leave the Door Open ( Door should not be locked when not in use to
prevent over compression of the seal).
18) Instruct customer on the use of the bath.
Refer to 'Operating/Care and Maintenance Instructions' and leave copy
with customer.
Do not leave door in locked position on completion. Advise customer that
the door should be left unlocked when not in use in order to preserve the
seal.
July 2013
Wet Rooms Direct
Telephone: 01685 898110
Email: [email protected] Website: www.wetroomsdirect.net
