background image

Oakmere

 Installation Guide.

The 

Oakmere

 is supplied with the following components:-

Bath with Left or Right Hand Door Opening – SHOWN BELOW AS LHS DOOR OPENING
Front Panel & optional End Panel
Twin Waste kit with Shallow Traps
2 x Wall fixing brackets

Other Items supplied required with contract 

Thermostatic Valve TMV22( high flow rate) -MUST BE INSTALLED IN ALL CASES 
Possible additional items:
Pump and flow switch. (Refer to Installation notes)
Bath/shower mixer/taps. (Refer to Installation notes.)

IMPORTANT NOTES

The bath is supplied with 4 adjustable feet fitted & has a water capacity of 200 litres (unoccupied) 
which may require pump assisted taps with a flow rate of 17 litres/min minimum. Use only 22mm 
pipe leads to enhance flow rate. Bath is filled only when user has entered and shut door, 
consequently taps must be thermostatically controlled.

Installation is similar as for a standard bath except that twin wastes are supplied to increase 
drainage rate & to ensure the bath can be drained if one waste fails. The bath should be installed 
rigidly to ensure there will be no movement or sagging of the floor when bath is used. 

Consideration should be given to lowering the wastes below the floor level to keep the step 
threshold to a minimum to assist customer’s ability to step into the bath.

If fitting in an alcove ensure the bath freely goes into position (as sideways pressure can distort 
the doorway).

The 

Oakmere

 is manufactured in glass fibre. When handling, proceed with care and

 

caution, in particular the bath edges are more brittle than in acrylic baths.

For ease of manoeuvrability we recommend the door be removed after unpacking 
the bath. The door is held in place with 'lift-off' hinges. Open the door then lift 
from bath.

Wet Rooms Direct

Telephone: 01685 898110

Email: [email protected]   Website: www.wetroomsdirect.net

Содержание Oakmere

Страница 1: ... thermostatically controlled Installation is similar as for a standard bath except that twin wastes are supplied to increase drainage rate to ensure the bath can be drained if one waste fails The bath should be installed rigidly to ensure there will be no movement or sagging of the floor when bath is used Consideration should be given to lowering the wastes below the floor level to keep the step t...

Страница 2: ...dently or joined by use of a tee Refer to fitting guides for the Thermostatic valve and Pump if supplied 11 Re hang door 12 Test plumbing for leaks 13 Fill bath to maximum and leave for about 30 minutes to test the door seal 14 While the bath seal is tested position and trim to size Front and Side 15 Mark bottom of panels onto floor base Fix battens along floor behind panels 16 Refit front and sid...

Страница 3: ...hinged side The door then automatically folds back on its self as shown above 2 In a standing position in bath shut door by pulling gently from the nearside central position of door Do Not pull from the far side as door will jam as shown above As door approaches closed position push outwards to engage the latch lock and lock the door Now be seated Bath is ready for use 3 After bathing remain seate...

Страница 4: ...d Brasso Brass Polish are suitable for this purpose Polishing the anti slip base should be treated with caution so as not to diminish its effectiveness 2 The stainless steel lock receiver on outer face of door can be polished occasionally with a to ensure it does not discolour It is recommended the latch lock is also lubricated on average once a year subject to the chlorine content in the water A ...

Отзывы: