Continuum Audio Caliburn, Руководство пользователя

Страница: 18 / 25

audible science audible science
FAULTS & TROUBLE SHOOTING
Whenever a fault or failure is detected, the
computer in the Control Unit will flash the
output “Q1” lamp at different pulse rate, to indicate the
different faults, these are listed in the table below.
To reset Alarms just operate the “Speed Lower” & “Speed
Raise” push buttons for 2 seconds.
To reset the Service Alarms, hold the push-button
pressed for at least 20 seconds
SERVICING
YOUR
CALIBURN
FAULT
CODE
FAULT FUNCTION DESCRIPTION RESET ALARM
1 pulse 33 r.p.m. CALIBRATION VR1 Not applicable
Adjustment mode ON
2 pulses 45 r.p.m. CALIBRATION VR2 Not applicable
Adjustment mode ON
3 pulses 78 r.p.m. CALIBRATION VR1 Not applicable
Adjustment mode ON
4 pulses 33 r.p.m. Push button
Adjustment mode ON Not applicable
5 pulses 45 r.p.m. Push button Not applicable
Adjustment mode ON
6 pulses 78 r.p.m. Push button
Not applicable
Adjustment mode ON
page 34