Continental Underfloor therM2, Инструкция по эксплуатации

Страница: 28 / 44

28
Section Header
28
Section Header
®
ther M
2
Re-calibrating therM
2
If you need to re-calibrate therM
2
, follow these steps.
• Use the left / right keys to scroll to the power icon ...................................
• Press and hold tick to turn the display off .....................................................................
• Press and hold the tick and down keys together for 4 seconds ....................
• The current temperature will appear on the display.
• Use the up / down keys to configure the new temperature value ..............
• Press the tick key to confirm the change and the display will go blank .............
• Press the tick key once to turn the thermostat on .....................................................
Error codes
E0 = The internal sensor has developed a fault.
E1 = The remote floor probe has not been connected.
The remote floor probe has not been wired correctly.
The remote floor probe is faulty.
E2 = The remote air probe has not been connected.
The remote air probe has not been wired correctly.
The remote air probe is faulty.
therM
2
will display an error code if there is a fault with the temperature sensor, these
error codes are explained below.