Continental Fireplaces CEFL50B, Инструкция по установке и эксплуатации

Страница: 11 / 20

11
W415-1290 / 07.13.15
EN
NOTE: Make certain new batteries are installed correctly.
A. Plug in your electric appliance.
B. Make certain the appliance’s Main Power Switch is at the ON position! The remote control will NOT
work if the Main Power Switch is at the OFF position.
C. When operating the remote control, it must be directed towards the front center of
the appliance.
D. The button at the top left of the remote can be used to power up or down the
appliance (the main power switch on the appliance must be in the ON position for
the remote to operate). Pressing this button activates the power to the appliance.
E. To activate fl ame brightness, press the "FLAME +" button and to make the
fl ame higher.
F. To activate fl ame dimmness, press the "FLAME -" button and to make the
fl ame dimmer.
G. To activate the heater, press the "HEAT" button. To prevent overheating, the
initial set-up heat level will be cool for 10 seconds before the heat comes on and
after the heater turns off.
H. To adjust the timer press the button. There are 9 programable settings, 30
mins, 1h, 2h, 3h, 4h, 5h, 6h, 7h, 7.5hrs maximum.
I. To turn off the appliance, press the button once.
NOTE: This remote control must remain within 8 meters or 26 feet (8m) of the appliance to be
effective and this range may be reduced as the battery power is depleted.
5.2 OPERATING BY REMOTE CONTROL
6.0 MAINTENANCE
6.1 CLEANING
NOTE: Always turn off the appliance and unplug from the outlet before performing
any cleaning or maintenance. Failure to do so could result in electric shock, fi re or
personal injury.
A. For metal components, use a soft cloth and dampen with a metal safe cleaning product. NOTE: Do
not use brass polish or household cleaners that can damage the metal trim.
B. For glass components, use a glass cleaner sprayed onto a cloth. Dry with a lint free cloth. NOTE: Do
not use abrasive cleaners or any cleaner that can scratch the surface.
C. For vents, use a vacuum with a soft brush or a duster to remove any dust or lint.
D. For plastic components, slightly dampen a cloth with a mild solution of dish soap and warm water
NOTE: Do not use abrasive cleaners or any cleaner that can scratch the surface.