Continental Fireplaces CBHD4N, Инструкция по установке и эксплуатации

Страница: 54 / 67

W415-1283 / E / 12.21.16
52
VALVE TRAIN REPLACEMENT
A. Remove the safety screen and main door(s). See "MAIN SAFETY SCREEN REMOVAL/INSTALLATION"
EN
and "MAIN DOOR REMOVAL/INSTALLATION sections for detailed removal instructions.
B. Remove the burners, see "BURNER REMOVAL" section.
C. Remove the 12 screws holding the valve train in place, as shown below.
NOTE: A new gasket may be required when reinstalling the valve train assembly. Contact your
local authorized dealer/distributor.
D. Carefully lift the valve train assembly out far enough to access the manual shut off valve and turn to
the off position. Disconnect the flex connector from the valve. You may now lift the valve train out of
the appliance.
RESTRICTING VERTICAL VENTS
Vertical installations may display a very active flame. If this appearance is not desirable, the vent exit must
be restricted using a restrictor vent kit. Refer to
“ACCESSORIES” in the “REPLACEMENTS” section for
the appropriate kit. This will reduce the velocity of the exhaust gases, slowing down the flame pattern and
creating a more traditional gentle flame appearance. Specific instructions are included with the kit.
77.3
NOTE: IF THE APPLIANCE HAS BEEN REDUCED TO 4/7" VENTING ONLY, USE AN RP4 TO RESTRICT
VERTICAL VENTING.