Continental Fireplaces CBHD4N, Инструкция по установке и эксплуатации

Страница: 45 / 67

W415-1283 / E / 12.21.16
43
7.3 BATTERY BACK-UP INSTALLATION
NOTE: In the event of a power failure, your appliance can be operated using the battery back-up supplied.
A. Remove the safety screen and door, refer to the "MAIN SAFETY SCREEN REMOVAL/INSTALLATION" and
EN
"MAIN DOOR REMOVAL/INSTALLATION" sections for detailed removal instructions.
B. Remove the panel cover using the two finger holes, then remove the control panel cover by lifting it up
and off of the four shoulder screws, this will allow you to easily access the battery housing.
C. Remove your battery housing to install the batteries, this will be located in the control compartment,
as shown below.
D.
Install the four “AA” batteries, ensure the positive and negative ends correspond with those identified
on the battery housing.
E. Place the battery housing back into position or let it rest on the hearth, for the duration of the power failure.
NOTE: Once the power has been restored remove the batteries from the battery housing. The system
will drain the batteries if they are left in the battery housing. It is recommended that you change the
battery at the start of the heating season.
BATTERY
HOUSING
PANEL COVER
CONTROL
PANEL COVER