C. USE
Step 1 : Connect the device to the electrical outlet.
Step 2 : Add water as shown in diagram A or diagram B. Do not exceed the MAX line.
When the appliance is making ice cubes and the indicator filling appears but you want
to make more ice cubes first, remove the ice first and add some water to prevent the water
tank from overflowing when the ice melts.
Step 3: Press ON / OFF to turn the device on or off.
Step 4: The water will be automatically pumped into the water pan from the water tank,
this process will take about 30 seconds.
Step 5: Select the « SMALL or LARGE » button to start ice making.
Note: When the room ambient temperature is lower than 15 degree, it is
recommended to choose S / SMALL, and when the room ambient
temperature is higher than 30 degree, it is recommended to choose L /
LARGE.
Step 6: The ice making cycle begins to operate, the ice will be frozen in the outlet of
the evaporator.
Note: The ice making time depends on the outside ambient temperature.
Step 7: When the ice-making cycle is complete, the water tray tilts forward, the remaining
water returns to the water tank, and the ice cubes fall through the outlet (5).
Step 8: After approximately 15 to 35 seconds, the water pan will tilt backwards, the ice
cubes formed during the previous cycle will be pushed directly into the ice container and
the appliance will be able to operate from step 4 to 3 again. step 6.
Diagram A - Add water
Diagram B - Connection to the water tap
Add water
EN
-15
