English
SFX-DE50W
-
50W White LED Profile spot with gobo holder an 15 to 30° zoom
Page 4
1
Locking latch
Allows to lock the filter holder.
2
ZOOM knob
This knob allows the beam width to be varied from 15° to 30°.
3
FOCUS knob
Use this dial to adjust the sharpness of the beam projection.
4
Gobo holder
This holder is used to insert a metal gobo.
The gobo must have dimensions:
- Total diameter: 25.8 mm
- Image diameter: 19 mm
5
Display and menu buttons
Display
Allows you to intuitively configure your device. Please refer to
next paragraph for more details about the menu functions. The
backlight can be turned off via the Backlight function from the
menu.
MODE
Button
ALlows you to access the menu and select a function.
ENTER Button
Allows you to enter sub-menus and apply changes.
UP and DOWN buttons
Allows you to increase or decrease parameter values.
6
USB port
This USB port is used exclusively for connecting a wireless DMX
dongle.
This dongle is used to control the projector via DMX protocol.
7
Power input
Allows you to power up your projector via Powercon
©
Power /
2 poles + earth cable. This cable is supplied with the projector.
Please make sure the voltage of your workplace matches this
projector.
8
Power output
Allows you to connect your projector to another projector with a
Powercon
©
Power male/female cord. This cord is not supplied
with the projector.
The maximum load accepted by this output is 16A.
9
DMX input
3-pin male XLR hardwired as follows:
- Pin 1: Mass
- Pin 2: Negative signal
- Pin 3: Positive signal
10
DMX output
3-pin female XLR hardwired as follows :
- Pin 1: Mass
- Pin 2: Negative signal
- Pin 3: Positive signal
11
Fuse
If need to change the fuse, please make sure the new fuse has
the exact same characteristics as the old one.
12
Filter holder
Allows you to add a colored filter and colorize your beam.
13
Horizontal blades
Allow you to split the beam horizontally.
14
Vertical blades
Allow you to split the beam vertically.
