English
IPSPOT7/12x10FIVE
-7/12 x 10W LEDs waterproof projectors
Page 5
4 - Internal menu
Menu
Sub-menu
UP and DOWN
Action
Menu
Set ADDR
Set Adress
XXX
Sets the DMX address. Values from 001 to 512.
Menu
UserMode
CH:
02/05/07/09
Allows you to determine the number of DMX channels used.
DMX modes:
-
2-channel mode
: Colours and Macros/Dimmer or speed
-
5-channel mode
: Red/Green/Blue/White/Amber
-
7-channel mode
: Red/Green/Blue/White/Amber/Dimmer/Shutter
-
9-channel mode
: Red/Green/Blue/White/Amber/Dimmer/Shutter/Colours
and Macros/Speed
Menu
Function
DimMode
LED/HALOGEN
Allows you to adjust dimmer speed:
HALOGEN
: Progressive dimmer
LED
: Instant dimmer
DimCurve
(Dimmer settings)
DimCurve
Linear
Brightness settings are exponential
DimCurve
Square
Brightness settings are inversely exponential
DimCurve
I-Square
Brightness increases slowly in lower values and strongly
in higher values
DimCurve
S-curve
Brightness increases linearly
NO DMX
Hold/Blackout/
Program
Allows you to select the behaviour of your projector in case of DMX signal
interruption:
Hold
: the projector holds onto its last DMX instruction.
Blackout
: the projector turns off.
Program
: the projector enters auto mode.
AUTO RUN
FQN:XX
Run automatic mode
1.STATIC
CL:XXXX
1.STATIC
STR:XXX
Run static colour mode
Then let adjust the strobe speed
2.CHANGE5
SPEED:XX
1.CHANGE5
STR:XXX
Run static colour mode
Then let adjust the strobe speed
3.CHANGE24
SPEED:XX
3.CHANGE24
STR:XXX
Run static colour mode
Then let adjust the strobe speed
Macros
XX
Run macros : from 00 to 63
Upon initialisation, the display will indicate:
Update
Wait ...
The projector will then check for available updates. It will then initialise, and the display will indicate:
IPSPOT
7x10FIVE
ou
IPSPOT
12x10FIVE
The projector is ready to be operated once both these steps are completed.
4.1 - Initialisation
4.2 - Menu tree
