Contest IPFLOOD5X15QC, Руководство пользователя

Страница: 8 / 20

English IPFLOOD5x15QC - 5x15W quadricolor LEDs battery operated wireless outdoor projector
Page 8
6 - DMX cabling and addressing
1
2
R
3
120 Ω 1/4W
Connecting the DMX remote control :
Connect the female plug of your XLR cable to your DMX remote control XLR output, then connect your cable
male output to the moving head. Daisy chain your moving heads with XLR cables.
Using a DMX line termination :
When long runs of cable are used (more than 100m, you may need to use a terminator on
the last unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4 watt resistor which
is connected between pins 2 and 3 of a male XLR connector. This unit is inserted in the
female XLR connector of the last unit in your daisy chain to terminate the line.
6.1 - DMX cabling
Address 1 Address 5 Address 9
6.2 - Addressing the units
Every unit must have a DMX address in order to respond to DMX signals. The address corresponds to the
channel number on which the unit receives an incoming DMX signal sent by the DMX remote control. The
DMX addressing can be performed by programming the channel number via the display located on the base
of the unit.
You can either assign the same address to your units so they all react to the same signal, or assign a unique
address per unit to control them independently.
IPFLOOD5x15QC uses 4, 6, 8 or 11 channels.
You must skip 4, 6, 8 or 11 channels betweeb each address you assign. In the following example, the
projector is in 4-channel mode :
The address of the first unit is 1, the second unit is5 (1+4), the third unit is 9 (5+4) and so on.
Note : Once switched on, the projector automatically detects any incoming DMX signal and the
display indicates the unit DMX address. If the unit does not receive any DMX signal, the display will
flash. In such a case, please make sure the cable is properly plugged into the DMX input of your
moving head, your remote control is switched on and the cables used are not defective.
DMX line termination
Remote control