Contemporary Research 11
ICC2-ATSC4
On-Screen Menus (IC Mode)
The remaining installation steps use the IR remote and the built-in character generator of the
ICC2-ATSC+.
1.
Change the IR Remote mode in front-panel menu 18 to
IC-RC (18.0).
This will enable the
character generator to display the menus below.
2.
Touch
Menu
, then
999
, then
Enter
.
3.
The text
CR MENU>
should appear on the screen.
4.
Key in one of the commands shown below, then press
Enter
to activate.
5.
Note that, in Menu mode, the
Channel Down
key acts as a backspace/delete key.
Command
Function
45678
Display firmware version
45679
Display the unit’s device #. At this point, you can use the Channel Down key as a
Delete key, enter a new device # with
the remote’s numeric keypad, then hit Enter to
save the new number.
45700
Display current projector/monitor control commands. The code is installed by CR
when the unit ships, codes can be changed over the RF.
See
RS-232 Control Codes
on the next page.
45718
IR Remote Type
0=IC-RC
1=HD2-RC
45719
Tuning Control
0=Tune all channels
1= Only tune channels in List
45720
Set Display/Projector Input
Enter code 1-19. See page 23 in the
ER
section for input codes
65478
Reset controller, similar to disconnecting power then restarting.
65487
Initialize to factory default settings: Power on, unlocked, display channel 11, channel
ring set to 4, 5, and 11, Group 0. Note that this command works even if TV power is
off or control is locked out.
65480
Enable constant Net transmit to the Head-End. This is used for measuring the signal
strength of the unit’s RF output. Press Enter to stop transmit or the unit will
automatically stop after 50 seconds.
65481
Display DA transmitter frequency control voltage
– should be 2000 - 3150.
65482
Display iCC-Net RF receive signal strength. Shows
Net RX
if receiving the
iC-
HE’s “heartbeat” pulse once per second,
!NET RX
if not.
65483
Display DF transmitter frequency deviation
– should be 245 - 300
