Contemporary Research Corporation
6
ICC/ICW Smart TV Controller
Installation
AC Power and Smart TV control
1.
Insert DC power supply plug into 12 VDC jack. Newer model RCAs (since 01/2000) with 8-pin jacks power
unit through data cable.
2.
Plug power adaptor into AC wall outlet, the Net LED should turn on and stay lit.
3.
Connect the included Smart TV data cable from the To TV jack to the TV’s data jack (Newer RCA TVs use
an 8-pin jack, insert the 6-pin plug in the middle of the 8-pin jack).
4.
The TV/COM LED will be off before inserting the cable, switches to on when communication is
established, flashes when a button is pressed on the TV or IR remote.
RF Coax and iCC-Net Operation (ICC2, ICC1)
1.
Connect the CATV RF Coax cable into the RF In jack.
2.
If the iCC-Net signal is operating, the Net LED will blink once per second.
3.
Connect RF loop cable (included) from RF Out to TV’s RF input.
iCW-Net Connection (ICW)
1.
Plug the iCW-Net RJ-45 connector into the iCW-Net input.
2.
If the iCW-Net signal is operating, the Net LED will blink once per second.
3.
Connect the CATV RF Coax cable to the TV’s RF input.
Using the IC-RC Remote for On-Screen Menus
In order to complete the setup, you’ll need the IC-RC IR Remote to use the On-Screen Menus. Typically, the
remote is shipped ready to communicate to Smart TV. Just in case, here’s how to set the IR codes in the remote:
1.
Press and hold the Select button and a numeric key for the code # below.
2.
Release the two keys at the same time.
3.
The remote will now send the selected codes.
4.
Remote will keep the codes, even if battery power is lost.
IR Code Format
Code
Zenith Smart TV
1
Philips Smart TV
2
RCA Smart TV
3
