Contec RP-COM(FIT)H, Руководство пользователя

Страница: 46 / 49

8. Appendix
RP-COM(FIT)H, RP-COM(FIT)H-AF
41
Table 8.4. Memory Register List < 2 / 2 >
Register number Function Access
Initial
value
Supplement
*REG085 Device ID of
opposing
station
R/W 0 0 - 255 Enable through mode only
(255: Broadcasting)
REG086 Command
input
timeout
R/W 3sec Inter-character monitor time
REG087 Response OK
("OK")
R/W Response 0: No response 1: Response
REG088 Response error
("E?")
R/W Response
altogether 11111111B E1 - E8
*REG089 Start with
receive data
output enabled
R/W Output
prohibition 0: Output prohibition 1: Output permission
0bit: Binary 1bit: Text 2bit: MAC
3bit: UDP
REG090 Reception type R/W 00000011B
Initial value = "Do not receive MAC or UDP"
0: Disabled
1: Enabled REG091 UDP port
setting
R/W Disabled
Only applies when UDP is set as the type of data to receive.
REG092
and above Minimum
value of UDP
port 1 R/W 6000h 0: With no setup
REG094
and above Maximum
value of UDP
port 1 R/W 6000h
REG096
and above Minimum
value of UDP
port 2 R/W 0000h
REG098
and above Maximum
value of UDP
port 2 R/W 0000h
REG100
and above Minimum
value of UDP
port 3 R/W 0000h
REG102
and above Maximum
value of UDP
port 3 R/W 0000h
REG104
and above Minimum
value of UDP
port 4 R/W 0000h
REG106
and above Maximum
value of UDP
port 4 R/W 0000h
Note that 5000h - 500Fh are reserved and cannot
be used. If specifying the UDP number during
operation, change the reception type to "do not
receive UDP".
Note : In the "Access" column, "R" indicates read.