Contec ADI16-4(USB), Руководство пользователя

Страница: 27 / 67

3. Setup
20
ADI16-4(USB)
Connecting to an External Device
Signal Layout
The Module can be connected to an external device using a 12-pin (1 group) connector that is provided
on the Module face.
Figure 3.5. Signal Layout on the Interface Connector < ADI16-4(USB) >
Connection Method
When connecting the Module to an external device, you can use the supplied connector plug. When
wiring the Module, strip off approximately 9 - 10 mm of the covering for the cable, and insert the bare
wire by pressing the orange button on the connector plug. Releasing the orange button after the wire is
inserted fixes the cable. Compatible wires are AWG 28 - 16.
Removing the connector plug by grasping the cable can break the wire.
Figure 3.6. Connecting an Interface Connector and Connectors That Can Be Used
12
11
10
9
8
7
6
5
4
3
2
1
CH0 [+]
CH0 [-]
AG
CH1 [+]
CH1 [-]
AG
CH2 [+]
CH2 [-]
AG
CH3 [+]
CH3 [-]
AG Analog Input 0ch [+]
Analog Input 0ch [-]
Analog Ground
Analog Input 1ch [+]
Analog Input 1ch [-]
Analog Ground
Analog Input 2ch [+]
Analog Input 2ch [-]
Analog Ground
Analog Input 3ch [+]
Analog Input 3ch [-]
Analog Ground
CH0
CH1
CH2
CH3
+
-
AG
+
-
AG
+
-
AG
+
-
AG
CAUTION
- Connector used:
3.81mm pitch 12 pin type of rated current 8A
MC-1,5/12-GF-3,81 (made by Phoenix Contact Corp.)
9 - 10mm
- Compatible plug :
Front-operable spring gauge type
FRONT-MC 1,5/12-STF-3,81 (made by Phoenix Contact Corp.)
Compatible wires : AWG 28 - 16
0
234
56
7
9A
CDEF
8
0
234
56
7
9A
CDEF
8