10
OUTLET HEPA FILTER AND FOAM FILTER III
The HEPA outlet filter should be replaced after about 30
hours of operation (6 months) or earlier in case of heavy dirt.
1
Remove the tank from the vacuum cleaner.
2
Place the vacuum cleaner with the “wheels upwards” so
that the upper sloping surface and the handle are rested on
the floor.
3
Slide the slider of the filter cover interlock to the “open”
position and remove the filter lid.
4
Remove the foam filter III
(12)
. Rinse or replace if the
filter becomes dirty. Remember to dry the filter before
reassembly.
5
Remove the foam filter III
(12)
and next remove the
HEPA filter by grabbing the handle. Replace with a new one
if the filter becomes dirty.
It is recommended to periodically inspect the condition of the
filter, especially if there was a water overflow to the outside of
the vacuum cleaner. In case of detecting damage (a break)
in the filter layer or if the layer is evenly covered with dust,
the filter should be replace with a new one.
6
If the HEPA filter is dirty, replace it with a new one or
rinse under running water. Remember to dry the filter before
reassembly.
7
Reinsert the filters, insert the filter lid and press firmly.
8
Slide the slider of the filter cover interlock to the “closed”
position.
Turn the vacuum cleaner to its natural position (on four
wheels).
J
TURBOBRUSH
K
A
B
1
2
3
4
6
5
4
