CONSTRUCTA CH17711, Руководство по эксплуатации

Страница: 8 / 50

Gas burners
Each control knob indicates which burner it controls.
To light a burner, push in the knob for the burner you
wish to use and turn it in an anti-clockwise direction to
the lighting position. Hold the knob at the maximum
position for a few seconds until the burner ignites and
then release and set the knob to the desired setting. If
the burner does not light at the first attempt, repeat the
operation.
If the spark plugs are dirty, then a fault may occur in the
ignition system. Keep them completely clean. Clean the
spark plugs using a small brush, remembering that the
plugs must not receive any kind of violent impact.
To turn the burners off, turn the control knob in a
Your modern functional hob is equipped with progressive
valves which permit you to find the perfect flame setting
between maximum and minimum.
Depending on the model that you have purchased, your
hob may come with a triple-flame burner, the perfect
system for cooking paellas, using woks, etc.
Gas appliances create both heat and humidity in the
room they are used in. Make sure that your kitchen is
properly ventilated: keep natural ventilation outlets open
or install a mechanical ventilation system (extractor fan).
When using your appliance for a prolonged period of
time, it may be necessary to provide additional ventilation
e.g. by opening a window (without creating a draught)
or turning up the setting on your mechanical ventilation
system.
Fig. 1.
(Fig. 1.)
clockwise direction to the setting.
If the burner goes out (e.g. a draught) when in use, the
If this ignition is unsuccessful (e.g. as a result of boiled-over
control knob to and check whether the cause can be
Every hotplate features a safety pilot!
This means that if the flame ever goes out (e.g. is
extinguished by boiled-over liquid), the flow of gas is
appliance will switch the hotplate on again automatically.
interrupted.
interrupted and an acoustic signal is emitted. Turn the
The safety system will indicate any anomalies in its
rectified using the table on page 11.
working through acoustic signals (see "Home
troubleshooting" section).
liquid on the burner), the flow of gas to this burner is
The appliance switches off automatically after 6 hours
of operation. Turn all the control knobs to the position
and then you can turn the appliance on again.
6