Basic settings
en
31
9 Basic settings
You can configure the appliance to meet your needs.
9.1 Changing basic settings
Requirement:
The appliance is switched off.
1.
Press and hold and
for a few seconds.
a
The display shows the first basic setting.
2.
Press .
a
The current value flashes on the display.
3.
Use the settings area to set the required value.
4.
Press .
a
The appliance implements the setting.
5.
Press
.
Tip:
The setting can be changed at any time.
9.2 Changing the signal duration
When your appliance is switched off, you hear an aud-
ible signal. You can change the duration of the signal.
▶
Press and hold for approx. six seconds.
a
The signal duration switches between short and
long.
a
The appliance applies the signal duration and dis-
plays the time.
9.3 Setting the time
Note:
After connecting the appliance to the power or
following a power cut, a signal sounds and several
zeros are shown on the display. It may take a few
seconds until a signal sounds and you can set the
time.
Requirements
¡
An audible signal sounds.
¡
12:00 is shown on the display.
¡
The indicator light lights up via .
1.
Set the time via the settings area.
2.
Press .
9.4 Hiding the clock
To reduce the standby consumption of your appliance,
you can hide the clock.
1.
Press .
2.
Press
.
To view the clock, press again.
10 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
10.1 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
▶
Do not use steam- or high-pressure cleaners to
clean the appliance.
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
▶
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
content.
▶
Do not use hard scouring pads or cleaning
sponges.
▶
Do not use any special cleaners for cleaning the ap-
pliance while it is hot.
▶
Only use glass cleaners, glass scrapers or stainless
steel care products if recommended in the cleaning
instructions for the relevant part.
New sponge cloths contain residues from production.
▶
Wash new sponge cloths thoroughly before use.
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
10.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of fire!
Loose food remnants, fat and meat juices may catch
fire.
▶
Before using the appliance, remove the worst of the
food residues and remnants from the cooking com-
partment, heating elements and accessories.
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
▶
Do not use any harsh or abrasive cleaners or sharp
metal scrapers to clean the glass on the appliance
door, as they may scratch the surface.
1.
Read the information on cleaning products.
→
2.
Observe the information on cleaning the appliance
components or surfaces.
3.
Unless otherwise specified:
‒
Clean the components of the appliance with hot
soapy water and a dish cloth.
‒
Dry with a soft cloth.
