CONSTRUCTA 4242004237112, Инструкция по установке и эксплуатации

Страница: 21 / 60

21
By hand:
Note:
You can use a special grease solvent for stubborn dirt. It
can be ordered via the Online Shop.
■
Soak the metal mesh grease filters in a hot soapy solution.
■
Clean the filters with a brush and then rinse them thoroughly.
■
Leave the metal mesh grease filters to drain.
In the dishwasher:
Note:
If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has no effect
on the function of the metal mesh grease filters.
■
Do not clean heavily soiled metal mesh grease filters together
with utensils.
■
Place the metal mesh grease filters loosely in the dishwasher.
The metal mesh grease filters must not be wedged in.
Installing the metal mesh grease filter
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
Note:
Clean all accessible parts of the housing.
Insert the metal grease filter and lock it in place. When you do
this, take hold of the metal grease filter from underneath with
your other hand.
Note:
Make sure that the metal grease filter is positioned
correctly.
Activated charcoal filters
Activated charcoal filters bind odorous substances in air
recirculation mode. With normal use (approx. 1–2 hours a day),
the activated charcoal filter should be replaced twice a year.
Notes
■
The activated charcoal filter is not included with the
appliance. The activated charcoal filter is available from
specialist retailers, from our after-sales service or from our
online shop.
■
The activated charcoal filter cannot be cleaned or reactivated.
■
Activated charcoal filters do not contain any harmful
substances and can be disposed of with your normal
household waste.
Fitting the activated charcoal filter
1.
Remove the metal grease filter.
2.
Insert the screw through the wing nut and the sleeve. Screw it
into the centre of the intermediate floor.
Note:
The screw, wing nut and sleeve are included with the
activated charcoal filter.
3.
If the appliance has a spacer rail, remove this. Use a
screwdriver to push the two tabs on the intermediate floor
inwards.
4.
Mask the activated charcoal filter using the enclosed sealing
strips.