48000035 Iss 11
3
Installation
If your appliance is to be used permanently in
a single location, it should be fixed to the wall
or floor..
W
ALL
M
OUNTING
I
NSTRUCTIONS
The appliance can be fixed to the wall in the
upright position as shown in diagram A with
the control panel at the bottom.
For rigid fixing of the appliance use 4 off no 8 x
1” long round head wood screws (not sup-
plied).
Mark on the wall the position of the keyhole
mounting holes making sure they are horizon-
tal and on 180 mm centers. Reference should
be made to Diagram A for mounting re-
strictions. Drill out holes and insert wall plugs.
Screw 2 screws into the wall until approximate-
ly 5 mm of the screws, excluding the head, is
left exposed, see Diagram C. Position unit on
wall locating screws into keyhole slots. Mark
off onto wall the 2 lower fixing screw positions;
remove the unit from the wall. Drill and wall
plugs lower fixing holes, and re-position unit on
upper screws and secure to the wall with low-
er fixing screws.
F
LOOR
M
OUNTING
/F
REE
S
TANDING
Your appliance can be used in the follow-
ing ways; diagrams A & B show size of unit and
minimum operating distances. Do not use this
heater in the immediate surroundings of a
bath, a shower or a swimming pool. The heat-
er must not be located immediately below a
fixed socket outlet. The heater can be fixed to
the floor in two ways as shown in Diagrams A &
B. For the method of fixing to the floor, refer to
wall mounting instructions which are very simi-
lar.
WARNING –
the appliances should not be
installed in the following ways.
