Consort Equipment Products Limited
Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT
Tel: 01646 692172 Fax: 01646 695195
Email: [email protected] Web: www.consortepl.com
Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm
BS EN ISO 9001 Registered Company No FM12671
13984134 Iss 1
4
Electrical Connections.
Single To 3 Phase Conversion.
IMPORTANT!
Only the QZWP45 can be used on
3 phase.
Please make sure you have read the Safety in-
structions and you are a suitably qualified
3phase electrician before
continuing.
•
Open electrical box on back of heater
•
Undo the screw in the terminal block clamp-
ing the 3 live cables coming from the lamps.
•
Move one of the cables to terminal marked L3
•
Move the second cable to terminal marked
L2
•
Make sure the remaining cable is still in L1 and
tighten up all the screws.
•
YOU SHOULD NOT TOUCH ANY OF THE NEU-
TRAL CABLES COMING FROM THE LAMPS
•
Now remove the mains cable and replace
with suitable rated 5 core 3 phase cable. This
must be high temperature silicon cable.
•
Heater needs to be connected L1, L2 L3, Neu-
tral and Earth.
Operation.
Note:
The infrared lamps in this heater are frag-
ile as such it is important that they are not sub-
jected to any unnecessary shocks or
vibration and is not moved when in use. Wait till
the heater has cooled down before moving.
•
WARNING!
Ensure you read, understand and
apply the safety instructions in Section 1 be-
fore using the heater.
•
Ensure the heater is at least 1000mm from any
object. The heater can be tilted from 45° to
90° set it to the required angle before switch-
ing the heater on. Adjust the heater angle by
loosening the two bolts on the wall mounting
bracket. Tighten the bolts again when the de-
sired angle is reached.
•
Ensure that the mains supply is adequately
protected and that the mounting bracket is
earthed, then switch on.
•
Make sure the heater is disconnected from
the mains supply before any cleaning is at-
tempted. Also allow the heater to cool
completely.
•
When the heater is no longer required,
switch off and if possible unplug the unit.
•
Clean the exterior with a soft damp cloth.
•
To replace any of the lamps, contact your
authorised dealer.
•
The mains lead is made from high tempera-
ture cable, not a standard PVC cable and
as such should not be replaced without
consulting a suitable qualified electrician.
Maintenance.
Note:
Before examining or carrying out any
maintenance ensure the heater has cooled
down and is disconnected from the mains
supply.
The heater contains no moving parts and
therefore very little maintenance is required
other than to ensure that there is no
excessive build-up of dust/dirt on the reflec-
tors or emitters as this can cause overheating
and premature emitter failure. To clean
the appliance, turn off and disconnect from
mains supply, allow to cool then wipe with a
damp cloth.
Spares.
Note:
Spare are available from your distribut-
er
Please quote the following Lamp codes when
requesting spares.
Model
QZWP45N QZWP30N QZWP15N
LH Lamp
HE791201 HE790901
-
Centre Lamp HE790901
-
HE790901
RH Lamp
HE791201 HE790901
-
