Changing the User adjustable rapid fire speed
These instructions are also available as a video from our website
www.consolecustoms.net
and also
our youtube page
www.youtube.com/consolecustoms
.
1. You first need to be in the user adjustable game mode. Use the procedure described on the
previous page to switch the controller to the correct mode.
2. Once in the user adjustable game mode. You will need to first hold in the rapid fire button
and while holding the rapid fire button press and hold the mode change button on the back.
You must hold in the rapid fire button first, before pressing and holding the mode
change button. If you do not follow this order you will just switch the game mode
instead of entering to programming mode.
3. Hold both the rapid fire button and the Mode change button for aprox 3 seconds. After 3
seconds you will see the player 4 LED come on for 1 second then go out. After you see this
you can release both buttons. You are now in the programming mode.
4. When you enter the programming mode the user programmable speed is set back to 6 shots
per second (166 milliseconds per sot). This is so you always know where you are at and also
allows the programming to be done with only using one button.
5. While in the programming mode every time you press the mode change button on the back of
the controller the firing rate will increase by 2ms. The player 4 LED will also flash. The rate
can be increased until you reach 25 shots per second ( 40 milliseconds per shot). At this point
the player 4 led will not flash and pushing the button will no longer increase the speed.
6. At any time you can test you speed by just pressing the rapid fire button.
7. Once you are at the desired speed follow steps 2 and 3 above to return to the user adjustable
game mode.
Tips:
• Every time you enter the programming mode the speed is set back to 6 shots per second (166
milliseconds per sot)
• Remember or better yet write down the number of times you pressed the button. So you can go
back and make adjustments if needed.
• This mode works in milliseconds each time you press the button the speed is decreased by 2ms. So
you can easily calculate you speed.
•
The default is 6 shots per second or 166ms. There are 1000 milliseconds in 1 second. So
1000/166 = 6.02 or approximately 6 shots per second.
•
If you press the button 20 times you are now at 126ms. 1000/126 = 7.94 approximately 8
shots per second.
• If you want to go slower in speed you must exit and re-enter the programming mode and start over.
Since there is only one button you can only make the rapid fire faster from the default 6 shots per
second.
