98
b) Switching outdoor sensors automatically
Switching between the available outdoor sensors and displaying their measured values can be carried out
automatically by the second receiver unit(automatic switching approx. every 3-4 seconds).
Press the "CHANNEL" (16) button for about 2 seconds. The "
" icon appears in the display when automatic
switching is activated.
To switch off this function, simply press the "CHANNEL" (16) button again for approx. 2 seconds until the "
" icon
disappears again.
c) Display of the MIN/MAX Values (Temperature/Humidity)
• The minimum and maximum values for each sensor are stored separately. This is why you first have to choose the
desired outdoor sensor by pressing the "CHANNEL" (16) button (CH1, CH2, CH3).
• By briefly pressing the "MEM" button (15), you can then switch in sequence between the display of the minimum
value ("MIN" on display ), the maximum value ("MAX") and the current value.
• If a minimum or maximum value is displayed ("MIN" or "MAX" appears in the display), you can switch to the values
of the other outdoor sensors with the "CHANNEL" button (16).
d) Deletion of MIN/MAX Values
• Activate the display of the MIN/MAX values with the "MEM" button (15) first for better control.
• Delete all stored MIN/MAX values by pressing the "MEM" button (15) for a longer period of time. Directly after
deleting, the currently measured temperature/humidity value is displayed as the minimum/maximum value.
e) Manually Searching for a Sensor
By pressing the "
" button on the front of the second receiver unit for a longer period of time (hold button for approx.
2 seconds), it initiates a new search for possibly existing outdoor sensors.
The icon for radio reception from the outdoor sensors flashes in the upper left of the display. Do not press any buttons
during this search.
Manual search may be necessary when there are reception problems or the batteries were exchanged in the outdoor
sensor or when you have bought an additional sensor.
Search may last for a few minutes and is completed automatically.
As described in chapter 13. a), the "CHANNEL" (16) button can be used to switch between the sensors. When a
sensor is present, the measured values are displayed in the upper display line; If sensors are not present, only dashes
are displayed as measured values in the display.
