As power supply, only use the supplied
mains adaptor.
Only connect the power adaptor to a nor-
mal mains socket connected to the pub-
lic supply. Before plugging in the power
adaptor, check whether the voltage stated
on the power adaptor complies with the
voltage of your electricity supplier.
Never connect or disconnect power adap-
tors if your hands are wet.
Never unplug the power adaptor from the
mains socket by pulling on the cable; al-
ways use the grips on the plug.
For safety reasons, disconnect the power
adaptor from the mains socket during
storms.
Do not touch the power adapter if there
are any signs of damage, as this may
cause a fatal electric shock! Take the fol-
lowing steps:
– Switch off the mains voltage to the
socket containing the power adapter
(switch off the corresponding circuit
breaker or remove the safety fuse,
and then switch off the corresponding
RCD protective switch).
– Unplug the power adapter from the
mains socket.
– Use a new power adapter of the same
design. Do not use the damaged
adapter again.
5.6 Solar module: (Rechargeable) bat-
teries
The rechargeable battery is permanently
built into the product and cannot be re-
placed.
Never damage the rechargeable battery.
Damaging the casing of the rechargeable
battery might cause an explosion or a fire!
Never short-circuit the contacts of the
rechargeable battery. Do not throw the
battery or the product into fire. There is a
danger of fire and explosion!
Charge the rechargeable battery regularly,
even if you do are not using the product.
Due to the rechargeable battery technol-
ogy being used, you do not need to dis-
charge the rechargeable battery first.
When charging, place the product on a
surface that is not heat-sensitive. It is
normal that a certain amount of heat is
generated during charging.
5.7 Camera module:
(Non-rechargeable) batteries
Correct polarity must be observed while
inserting the battery.
The batteries should be removed from the
device if it is not used for a long period
of time to avoid damage through leak-
ing. Leaking or damaged batteries might
cause acid burns when in contact with
skin, therefore use suitable protective
gloves to handle corrupted batteries.
Batteries must be kept out of reach of chil-
dren. Do not leave batteries lying around,
as there is risk, that children or pets swal-
low them.
All batteries should be replaced at the
same time. Mixing old and new batteries
in the device can lead to battery leakage
and device damage.
Batteries must not be dismantled, short-
circuited or thrown into fire. Never re
-
charge non-rechargeable batteries. There
is a risk of explosion!
5.8 Privacy and surveillance
It is the responsibility of the user to be aware
of all applicable laws and regulations that pro-
hibit or limit the use of cameras, and to comply
with the applicable laws and regulations.
5.9 Mounting
Risk of fatal electric shock! Before drilling,
check for concealed wires or pipes beneath
the surface that could be damaged or cause
harm.
6 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Disconnect the product from the power supply.
2. Wipe the housing / solar panels with a slightly moistened damp cloth.
3.
Keep the solar panels clean to maximize charging efficiency.
7 Disposal
7.1 Product
This symbol must appear on any electrical and electronic equipment placed on the
EU market. This symbol indicates that this device should not be disposed of as
unsorted municipal waste at the end of its service life.
Owners of WEEE shall dispose of it separately from unsorted municipal waste.
Spent batteries and accumulators, which are not enclosed by the WEEE, as well
as lamps that can be removed from the WEEE in a non-destructive manner, must
be removed by end users from the WEEE in a non-destructive manner before it is
handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back
of waste. Conrad provides the following return options
free of charge
(more details on our
website):
in our Conrad offices
at the Conrad collection points
at the collection points of public waste management authorities or the collection points set
up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in
countries outside of Germany.
Important Information
Hunting Camera
Item No. 2476051
1 Intended use
The product is intended for use as a 4K out-
door hunting camera. A mobile application is
available for download.
Ingress protection
The product is suitable for outdoor use,
please note the following information.
The ingress protection rating is:
Camera module (IP66): protection
against dust and high pressure wa-
ter jets from any direction.
Solar module (IP65): protection
against dust and low-pressure water
jets from any direction.
Ingress protection is only effective when:
Camera module: the compartment
and
DC IN
covers are closed.
Solar module: is attached to the
camera and the rubber
DC IN
cover
is closed.
For safety and approval purposes, you must
not rebuild and/or modify this product. If you
use the product for purposes other than those
described above, the product may be dam-
aged. In addition, improper use can result in
short circuits, fires, electric shocks or other
hazards. Read the instructions carefully and
store them in a safe place. Make this product
available to third parties only together with its
operating instructions.
All company names and product names are
trademarks of their respective owners. All
rights reserved.
Google Play and the Google Play logo are
trademarks of Google LLC.
2 Delivery content
Camera module
Solar rechargeable battery module
Strap
Power adaptor
USB data cable (USB-A male to USB-B
male)
Mounting kit
(3x screws, 3x wall plugs, wall plate,
double-ball joint)
Operating instructions
3 Latest product information
Download the latest product information at
www.conrad.com/downloads
or scan the QR
code shown. Follow the instructions on the
website.
4 Symbols in this document
The symbol warns of hazards that
can lead to personal injury. Read
the information carefully.
The symbol warns of dangerous
voltage that can lead to personal
injury by electric shock. Read the
information carefully.
5 Safety instructions
Read this document and the ac-
companying operating instruc-
tions carefully and especially
observe the safety information.
If you do not follow the safety
instructions and information on
proper handling, we assume no
liability for any resulting person-
al injury or damage to property.
Such cases will invalidate the
warranty/guarantee.
5.1 General information
The device is not a toy. Keep it out of the
reach of children and pets.
Do not leave packaging material lying
around carelessly. This may become dan-
gerous playing material for children.
If you have questions which remain un-
answered by these operating instructions,
contact our technical support service or
other technical personnel.
Maintenance, modifications and repairs
must only be completed by a technician or
an authorised repair centre.
5.2 Handling
Please handle the product carefully. Jolts,
impacts or a fall even from a low height
can damage the product.
5.3 Operating environment
Do not place the product under any me-
chanical stress.
Protect the appliance from extreme tem-
peratures, strong jolts, flammable gases,
steam and solvents.
5.4 Operation
Consult an expert when in doubt about the
operation, safety or connection of the ap-
pliance.
If it is no longer possible to operate the
product safely, take it out of operation
and protect it from any accidental use.
DO NOT attempt to repair the product
yourself. Safe operation can no longer be
guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods
in poor ambient conditions or
– has been subjected to any serious
transport-related stresses.
5.5 Power adapter
Do not tamper with power sup-
ply components. Risk of death
by electric shock!
Always ensure proper con-
nection.
Never use damaged power
supply components.
Do not modify power supply
components.
Connect the appliance to a wall socket
that can be accessed easily.
