15
• Go to the PC interface and insert four C-type batteries with correct polarity
(follow figure in the battery compartment).
• The PC interface makes contact with the alarm base station by transmitting
a radio signal. The red LED on the circuit board of the PC interface briefly
lights up, the alarm base station emits a brief signal tone to confirm receipt.
• If you also wish to use a power supply, connect the ‘BU1’ socket (see figure
1 on page 10) with the power supply’s low-voltage output.
• Close the PC interface’s casing. The two faceplates must audibly click in.
• Plug the power supply into a socket.
• Return to the alarm base station. The LCD’s
display has changed.
• Confirm the installation by pressing the ‘
OK
’
button.
• Press the ‘
w
C
’ button twice to return to the normal
display mode (top level of the alarm base station).
• When programming the PC interface, please follow the instructions in the
user manual of the ‘FAZ 3000-Z’ alarm base station.
PC interf.
installed
sensors
add
disarm
16:35 14.12