16
| Transmitter
11.4.11 Firmware update
Navigate and set:
System > OK > Firmware update > OK > UP/DOWN > OK
Latest firmware releases are available from
www.rclogger.com. Check regularly.
A Windows
®
computer with USB interface is required for updating the firmware.
1. Turn the »Transmitter off.
2. Disconnect the »Receiver from the power supply.
3. Connect the trainer plug of the USB cable (supplied) to the trainer port
TRAINER
and
the USB A-type plug to a free USB socket (USB2.0 or USB3.0) on the computer.
4. Turn the »Transmitter on.
5.
Navigate to the firmware update section in the »Transmitter’s menu and start the
update procedure. Confirm the confirmation prompt if you are ready to continue or else
cancel the update procedure.
6. Follow the computer's instructions to complete the update.
7.
After the firmware has been updated, disconnect the USB cable.
8. Turn the »Transmitter off and on again.
9. The »Transmitter is ready for use.
11.4.12 Factory reset
Navigate and set:
System > OK > Factory reset > OK > OK > UP/DOWN > OK
This function will reset all »Transmitter settings to their factory default values.
Important!
Note that all system and modes settings will be lost and cannot be recovered
once the reset process is in progress.
11.5 Functions settings
In the functions settings menu you adjust the settings for each model. Before you start to
make adjustments, select a model in the System Settings (see
'11.4 System settings' on page 13).
11.5.1 Reversing channels
This function lets you reverse channels (see
) . Set the channels according to your
needs and preferences:
Ch
= Channel,
Nor
= Normal (Default),
Rev
= Reversed
Navigate and set:
Functions > OK > Reverse > OK > UP/DOWN > OK > ... > OK (long)
Use the key
OK
for navigating between the channels (CH1 – CH8).
Fig. 6
Reverse
1 2 3 4 5 6
Ch
Nor
Rev
11.5.2 End points
This function lets you set the travel of each channel (see
). Reduce travel with
smaller and increase travel with larger values.
Navigate and set:
Functions > OK > End points > OK > UP/DOWN > OK > ... > OK (long)
Fig. 7
Ch1 100% 100%
Ch2 100% 100%
Ch3 100% 100%
Ch4 100% 100%
Ch5 100% 100%
Ch6 100% 100%
End points