Conquip Powerbrush, Руководство пользователя

Страница: 14 / 21

15
Original Working Instructions
Usage Instructions
6. Check that the water is distributing correctly. Turn the water on. Make sure
it is coming out of the spray bar and the water is coming out of each hole or
spray nozzle. Now turn the water off until ready to start sweeping.
7. Connect to the telehandlers’ hydraulics to check that the brush rotates and
the hopper can open and close.
If you have a kerb brush fitted:
8. Check that the kerb brush is lowered to the ground using the chain and
catch system on the side of the sweeper. The bristles should be touching the
ground very slightly with a small deflection where the bristle meets the floor
Connecting the Powerbrush to your Forklift
1. To attach the Powerbrush to a forklift, set the machine’s forks to the correct
width for the Powerbrush fork pockets. Make sure that they are equidistant
from the centre.
2. Drive the telehandler to the Powerbrush aligning the forks with the
Powerbrush fork pockets.
3. Double check that all is correctly aligned, then move the telehandler forward
until the forks are fully inserted into the fork pockets.
4. Apply the park brake and switch off the forklift engine.
5. Release any pressure in the auxiliary hydraulic line of the forklift by operating
the control lever with the engine off.
6. Remove the heel pins from the heel pin storage by removing the linch pin.
7. Insert both heel pins into the holes behind the heel of the forks and use
the linch pins to lock the heel pins in place, securing the forks within the
Powerbrush fork pockets.
8. Take the 2 hydraulic hoses from the Powerbrush and connect them to
the 2 outputs on the arm of the forklift. The quick release female on the
Powerbrush connects to the male on the forklift. The quick release male on
the Powerbrush connects to the female on the forklift. The Powerbrush is
now ready for use.
NOTE: Configuration may differ on different forklift make and models.