IR Swift+ Soundfield Quick Guide – Transmitters
Pull out the old batteries. Replace with two new rechargeable
batteries,
taking care to place the battery with the exposed end
in the side with the spring at the mic head end
and the contacts
beside the spring. This is essential for correct charging.
When replacing
batteries, the
initial charge
will take approx.
10-15 hours.
To open the battery compartment, unscrew the metal
sleeve below the switch and slide the cover off.
Left battery:
High capacity
rechargeable
AA battery
MBRAAHX4VA
(sold in packs of 4)
Right battery:
High capacity rechargeable AA
battery ‒ fit the exposed end against
the spring and the side contact.
MBRAAHX1VAM
Swift
TX
pendant transmitter ‒ battery
Handheld transmitter
‒ battery
The battery is fitted with the exposed
metal end against the spring. Position
the battery on top of the ribbon tab
for easy removal next time.
Use
only with the exposed metal end
battery as supplied with the Swift
TX
.
Other types of battery will not charge.
When replacing batteries, the initial
charge will take approx. 10-15 hours.
To open battery
compartment,
press in the centre
of the battery door
with both thumbs
and slide off.
Charge socket
Technical Note
- when a rechargeable battery is first inserted, the Swift
TX
will test the battery to make sure it has enough charge. The indicator will
show orange for 5 secs while it is testing, followed by green (enough
charge) or red (needs charging) for 1 sec.
A flickering indicator or no
indicator ‒ the battery has no charge
and needs to be recharged or
replaced.
Charging the IR Swift+ pendant transmitter
Charge the Swift
TX
pendant every evening.
Switch off the transmitter before charging.
Use the external charger
45IRTXCHG2
plugged into a mains socket. Turn on
power and the red charge indicator
will light.
Charge time from flat for the
Swift
TX
transmitter is 12 hours.
It is safe to leave on charge for
up to 5 days.
45IRTXCHG2
Connevans Limited
Helpline: 01737 247571
Bridge House, 1 Nutfield Road, Merstham, Surrey RH1 3EB
www.SchoolSoundfield.co.uk
Swift
TX
Pendant
Charge
socket
Aux
socket
Microphone
socket
On/Off/Mute
Using the microphone
The microphone should be worn
approximately 15cm
(the length of a biro)
away from the mouth.
It is important when
using IR Swift
microphones not to
cover the infra red
emitter. The front
of the emitter
must face
forwards.
Swift
TX
pendant mic
On/Off
IR emitter
IR emitter
Charge Socket
MBRAAHX1VAM
7
7
Handheld transmitter
Volume ‒
Status indicator:
Green =
on
Alternating red/green = recharge soon
Red =
charging
Orange = charged
Battery charging
Replacing rechargeable batteries
Charging the handheld transmitter
Depending on use, the handheld mic may only need
charging every 1-2 weeks (approx. 8 hours use).
Switch off the handheld mic before charging.
Use the external charger
45IRTXHCHG2
plugged into a mains socket.
Charge time is 16-20 hours
from flat (i.e. overnight).
The batteries in all of these transmitters will last approximately 2 years.
45IRTXHCHG2
To conserve power always remember to switch the transmitter off when not in use.
Exposed end
rechargeable
battery
B45SWIFTQG4 V4.0
Side contact
Exposed
metal end
Handheld microphone
Hold in middle to avoid
blocking IR emitters
2.1mm
1.3mm
Exposed
metal end
