www.connects2.com
2
Connects2
Vision
CAMERA INSTALLATION
1. Remove the license plate from the vehicle
(Fig. 1)
2. Mark the location where the reversing camera
will be installed (left, middle or right).
(Fig. 2)
3. Tear off the 3M tape on the back of the cam-
era bracket, and fix the camera at the marked
location.
(Fig. 3)
4. Tear off the 3M tape on the front of the cam-
era bracket and fix it to the license plate. Then
tighten up the screws to fix the license plate in
place.
(Fig. 4)
5. Find a suitable opening/drill hole near the
license plate opening into the interior of the
vehicle. For added visibility and easy installation,
remove the interior trim near the license plate.
(Fig. 5)
6. Now run the camera cable to connect to the
power box in the vehicle’s interior/cavity. Be sure
the cables
aren’t pinched or knotted. Connect the plug
of the camera cable to the 4-Pin socket of the
power box.
(Fig. 6)
7. Open the inner plastic panel and remove it
from the hatch or tailgate. Test the wires with a
multimeter to find the reverse light power wire.
Connect the red wire from the power box to the
reverse light power wire. Then connect the black
wire from the power box to a ground source
(vehicle chassis).
(Fig. 7)
8. Secure the rear camera cable and power box
cable with cable ties in the rear carriage. Be sure
thereare no electrical loads or metal between
the monitor and antenna to avoid impairing the
transmission.
9. Put the car charger into the vehicle’s cig-
arette lighter to power on the monitor. If the
power box is correctly connected, a signal will
be transmitted to the monitor when putting the
car into reverse and the monitor will display the
camera image.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
