Connected Essentials Splash-proof, Руководство пользователя

Страница: 3 / 5

Setting Up The Speaker Receivers
1. Speakers can be powered by batteries (not supplied) or from the mains.
•If using batteries, Insert 6 x ‘C’ size
ALKALINE batteries into each of the
speakers battery compartments, ensure
with the correct polarity is used when
inserting the batteries.
•or connect the supplied 9V power adaptor
to the DC input jack on the bottom of each
speaker, then plug it to the wall AC outlet.
2. Press On/Off button and turn the speakers
ON. The POWER LED will light up in Blue.
To switch off the speakers press the ON/OFF
button on the speakers or on the remote
control unit, and the LED will switch off.
3. These speakers also have the added
advantage of being wall mountable. There
are two holes at the back of each speaker
for you to hang them on the wall. (Be sure
to use suitable hanging brackets or screws)
NOTE: WALL MOUNTING TEMPLATE ON THE BACK PAGE OF THE MANUAL?
Setting Up the Remote Control
1. Remove the battery cover at the rear of the remote control unit and insert 2 x “AAA”
size batteries (included) into the battery compartment following the correct polarity.
2. Replace the cover and close the battery compartment.
Operation
1. Switch on the audio source (TV or audio component) to which the transmitter is
connected to. The blue signal LED on the transmitter will light up.
2. Select transmitter channel 1 or 2. You may need to try each one in turn for the best
performance in your location.
3. Turn on the ON/OFF button on the speakers (the ON/OFF button on the remote control
unit cannot be used as a primary device to switch on the speakers). Press the “AUTO
TUNE” button to get the best tuning reception in the speakers. When the button is
pressed, frequency tuning starts automatically and it stops when a signal is detected.
4
The tuning process can also be activated by pressing the
“AUTO TUNE” button on the remote control unit.
4. Volume can be adjusted up by pressing the “+” button
or down by pressing the “-“ button “-“ to the desired
listening level, or you can press the “+” button or “-“
button” on the remote control unit to adjust the volume
level.
Tips for Clear Reception
a) Keep a distance of the speakers up to 7 meters apart
from the transmitter, and then press “AUTO TUNE” button
for the best reception.
b) If you get interference, move your channel switch from one channel to the other
channel (there are two channels for selection) on the transmitter, and then press the
“AUTO-TUNE” button again.
Note
You should now be able to moveplace the speakers freely from room to room without
interferance. Should there be any interferance (signal cuts off or carries distortion), press
the speaker’s “AUTO TUNE” button to maximise the best reception.
If you hear interference from other components, switch on the channel control of transmitter,
and then move the speakers to other free location. You can re-adjust the tuning control by
changing between either channel 1 or 2 of the transmitter, then pressing “AUTO TUNE”
button on the each speaker for best reception.
The signal from the system will become weaker when transmitting / receiving over longer
distances. Remember, the maximum range of 100 metres is in ideal conditions. Walls, furniture
and so on between the transmitter and speaker(s) will reduce the transmission range.
Switching Off
Press the ON/OFF button to turn off the speakers and the LED light will goes off, or simply
press the ON/OFF button on the remote control unit. If you use the remote control unit to
turn off the speakers, the speakers will be at stand-by mode for 5 minutes and the LED
5