Connect Tech PCIe/104 to PCI Express Adapter - Bottom Stacking Model - User Manual
CTIM-00056 (0.00) 11/24/2011
www.connecttech.com
6
800-426-8979 | 519-836-1291
Auxiliary Signals Jumper Block
Position A:
Should only be installed when you SBC power
supply does not 3.3V to the PCI/104-Express bus.
Position B:
In some cases PCI/104-Express SBC require
the PEG_ENA signal to be enabled to use the x16 lane bus,
if your SBC requires this please install this jumper.
USB Port Connector Pads
USB Type “B” connectors can be optionally installed by the
user. These ports will directly interface with the USB_0 and
USB_1 on the PCI/104-Express bus. The is also an option to
connect the shell of the USB connector to the PCB ground.
Compatible USB connectors:
Manufacturer
Part Number
Tyco
292304-X
Tyco
1734176-X
Samtec
USB-B-S-X-X-TH-X-XX
FCI
61729-XXXXBLF
Contact
for others.
3. Hardware Installation
PC104 Stand-Offs
When installing your PCI/104-Express SBC system onto ADG021, four proper stack height (0.
6”) PC/104
standoffs must be used.
If standoffs are not used, there is a high likelihood that the PCI/104-Express
connector will be damaged.
4 x PC/104 standoffs, 4 x PC/104 nuts and 4 x PC/104 screws are provided to
complete your PCI/104-Express SBC installation to the ADG021.
Support Bracket Installation
The ADG021 product ships with a
Standard Height PCI Express Custom Support Bracket
that can be
optionally installed to provide greater stability to the PCI Express add-on card installed into your PCI/104-
Express stack.
Installation steps:
1.
Insert bracket into alignment holes (see photo above for bracket location on PCB)
2.
Install and tighten each of the 4 supplied nuts.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
