Connect One
II-EVB-363NW User’s Manual
4
1. Introduction
This manual is intended to familiarize customers with Connect One’s Instant Internet
Evaluation Board II-EVB-363. The II-EVB-363 is an evaluation platform for the
Nano WiReach™ WiFi Module, Nano LANReach and Nano SocketLAN. The
Connect One Nano modules are secure serial-to-WiFi / serial-to-LAN modules that
also act as a bridge to connect serial devices to Ethernet or 802.11b/g wireless LANs.
The Nano modules fit into a compact form factor and utilizes Connect One’s iChip
CO2144 IP Communication Controller
™
and the AT+i
™
command set, a powerful set
of Internet protocol commands developed by Connect One to manage Internet
connectivity through an Ethernet or wireless LAN connection.
Nano modules enable sending and receiving textual and binary data, MIME-encoded
email messages; downloading HTML pages or files from a Web server, or items from
within a page; Web serving, as well as managing TCP or UDP socket
communications (with or without SSL3) over the Internet. It also includes an FTP
client and a TELNET client.
Nano WiReach can easily connect existing LAN based solutions to a WiFi network
when used in bridging mode.
Nano WiReach supports numerous WiFi security protocols such as 64/128-bit WEP
encryption, AES-CCM and TKIP encryption, WPA (including AES) and WPA2 in
both PSK and Enterprise modes. The Nano modules also support the SSL3/TLS1
security protocols.
2. Unpacking
Take the II-EVB-363 out of its box. Included in the box are:
•
The II-EVB-363 motherboard including
o
363MW: Nano WiReach module
o
363ML: Nano LANReach module
o
363MD: Both Nano modules
•
A serial cable with two DB-9 connectors
•
A USB cable
•
Antenna (in 363MW and 363MD)
•
+9VDC Power supply adaptor (110/220 VAC)
•
A single 30-pin female receptacle connector for prototyping on your own PCB
3. Connections
1.
Communications Cable:
•
Serial RS232:
Connect one end of the RS232 cable to the D-shell, 9-
pin female, Host RS232 port on the II-EVB-363 (J4) and connect the
other DB-9 connector to the COM1 or COM2 serial port on your PC,
or to the serial port of your embedded device.
•
USB
: Connect one the device end of the USB cable to the EVB-363
USB connector (J1) and connect the other end to a Host USB port on
your PC or embedded device.
2.
Connect the II-EVB-363 to the power supply.
