Connect One II-EVB-300, Руководство пользователя

Страница: 4 / 18

II-EVB-300 User Manual 23-3460-00
September 2004 4
•
Connect one end of the phone cable to the II-EVB-300 (J10) and connect the
other end to the wall phone jack.
•
Connect one end of the Ethernet cable to the daughter board (J3) and connect
the other end to an Ethernet wall socket, Ethernet switch or hub.
•
Finally, connect the II-EVB-300 to the power supply.
Installing the II-EVB-300 Utilities and Evaluation Program
II-EVB-300 enables the user to evaluate the iChip without changing anything in the
user’s current development environment. That is, using a simple terminal program on
a PC, the user can issue AT+i commands to the iChip and get responses. AT+i
commands are used to configure iChip parameter values into iChip’s flash memory
and activate Internet tasks such as email Send/Receive, Web access, sockets, FTP
sessions, etc. A full description of the AT+i protocol can be found in the AT+i
Programmer’s Manual on the release CD or on Connect One’s Web site at
http://www.connectone.com ,in the Documentation section.
To aid the user to easily evaluate iChip, Connect One supplies the iChipConfig
Utility. This is a Windows-based GUI program that contains intuitive dialog boxes to
fully configure iChip, without needing to be familiar with AT+i commands. It also
contains a local iChip firmware upgrade functionality. iChipConfig utility also
supports performing specific Internet communication tasks such as sending and
receiving Emails, activating iChip’s Web sites, entering SerialNET mode, etc.
The latest iChipConfig Utility version and User Manual can be found on the release
CD or on Connect One’s Web site at
http://www.connectone.com in the Support
section. Additional information on the iChipConfig utility and its usage, may be found
in the iChipConfig Utility User’s Manual.