CONIC ART LED TRIANGLE, Инструкция по эксплуатации

Страница: 25 / 25

Safety introduction and product maintenance
安全介绍及产品保养
1. The power connec(on must be made by professionals.
2. Make sure that the use voltage is not higher or lower than the specified value in the instruc(on
manual.
3. Confirm that the power cord is not cut or damaged by a sharp blade.
4. Be sure to disconnect the power supply when the lamp is not in use or before cleaning.
5. Only the plug is allowed to connect the power cord. When pulling out the plug, please do not
pull the power cord forcibly.
6. Be careful when installing the lamps and avoid touching the bare wires, otherwise you will
suffer a fatal electric shock.
7. Please do not look directly at the light source when the lamp is in use, otherwise your eyes will
be hurt.
8. When choosing the installa(on loca(on, please ensure that the lamp is not exposed to
extreme heat, humidity or dust. The distance between the lamp and the illuminated object must
exceed 0.5 meters. Make sure that there are no flammable and explosive materials within 0.5
meters.
9. Please use proper and safe wires to connect the lamps.
10. Please operate aaer familiarizing with the func(on of the lamp. Most of the damage to the
lamps is caused by improper opera(on, so non-professionals are not allowed to operate the
lamps. Do not shake the lamp at will, and do not operate it roughly.
11. Please do not modify the lamp at will. Doing so may cause short circuit, burning, electric
shock, etc., and cause malfunc(on and damage of the lamp. The manufacturer does not
provide warranty
1
，要由专业⼈员进⾏电源连接。
2
、确认使⽤电压不要⾼于或低于使⽤说明⼿册的规定值。
3
、确认电源线没有被利刃划破或损坏。
4
、灯具在不⽤时或在清洁前⼀定要断开电源。
5
、只允许⽤插头连接电源线，在拔插头时请不要⽤⼒拽电源线来拔出插头
6
、在安装灯具的过程中要⼩⼼操作，避免触摸裸露的电线，否则会遭受致命电击。
7
、灯具在使⽤时请不要直视光源，否则眼睛会受到伤害。
8
、在选择安装位置时，请确保灯具不被暴露在极热、潮湿或灰尘的地⽅。灯具和被照射物
体之间距离必须超过
0.5
⽶。确保在
0.5
⽶距离内没有易燃易爆物品。
9
、请使⽤适当的、安全的电线连接灯具。
10
、请在熟悉了灯具的功能后再进⾏操作。灯具的损坏⼤多数是由于不正当操作引起的，
因 此不允许⾮专业⼈员操作灯具。使⽤时不要随意摇晃灯具，不可粗暴操作。
11
、请不要随意修改灯具，这样做可能会导致灯具出现短路、燃烧、电击等现象，⽽且因
此 ⽽造成灯具的故障和损坏，⽣产⼚家不予保修。