Congo Play Bridge and Tower Add-On, Руководство по сборке

Страница: 13 / 41

PHASE 3
FRAME ASSEMBLY
TABLE 3 - PARTS AND HARDWARE
STEP 1: Gather parts and hardware shown in table 3.
STEP 2: With offset holes down., Attach base board 'G'
to upright 'B'.
base board will attach with 05/16" x 4 1/2" hex
bolt and 05/16" flat washer into bottom holes
and 05/16" x 3" lag screw and 05/16" flat
washer into top holes.
NOTE:
Use carpenter square to ensure board 'L'
and 'G' are square to the upright before
attaching the base board 'G' with
05/16" x 3" Lag Screws and 05/16" flat
washers.
STEP 3: With offset holes up., Attach fort rail 'L' to upright 'B'.
with 05/16" x 3 " lag screw and
05/16" flat washer.
05/16"x3" Lag Screw
05/16" Washer ,
STEP 4: With offset holes up.,cAttach base board
'G'
to upright
'B'
with
05/16
11
x3
11
lag screw
and
05/16
11
flat washer.
,.-------- - - - - - -
-----.....
(
'
I I
I I
I
T-Nut
I
I I
I I
I
NOTE:
I
I
Place Bolt in opposite side. Start preliminary
I
l
tightening of bolt into t-nut by hand.
)
Tighten each bolt with a wrench.
DO NOT OVER TIGHTEN
'----------�
05/16"x3" Lag Screw
05/16" Washer ,
'
1' 05/16",c 4 1/2" Hex Bolt
05/16" Washer
05/16"x3" Lag Screw
05/16" Washer ,
'
'
'-
8
6
L
FORT UPIWiHTS - 4 x 4 x 93 - 3 Holes
BASE BOARD - l x 6 x 46'/e - 4 Holes
FORT RAIL - l x 4 x 46'/e - 2 Holes
05/16"x3" Lag Screw
05/16" Washer '
'-
05/16"x3" Lag Screw
05/16" Washer
,,
05/16"x 4 1/2" Hex Bo�
05/16" Washer
05/16"x3" Lag Screw
05/16" Washer
,,
'
Q1Y
2
2
l
8
2
10
T-rwt