Confycare EL08, Руководство пользователя

Страница: 11 / 16

EN
9
EL08FS Stationary Chiropractic Table
OPERATION
Connect the bed to an electrical outlet using the power
cord.
Moving and adjusting the table
The bed bottom frame is equipped with two control
casters and two adjustable feet.
Empty the head of the bed and make sure that the
casters at the rear of the bed are active.
Adjusting head angle and head drop
operation
● Lift up the pull rod ①
in Figure 4 to adjust head
plate angle.
● Lift up the pull rod
②
in Figure 4 to activate
head plate drop section. Then press down the
head plate to achieve the effect of the drop
pressure.
Figure 1 Caster position
When the table top is lowered, the bed is in a stable
status.
The column at the front side of the base frame is
equipped with adjusting feet for adjusting the height.
After moving, please confirm whether the two
adjusting feet are in full contact with the ground,
otherwise rotate the feet for adjustment.
①
Figure 4
Adjusting head plate width
As shown in Figure 5, pull the control lever
(in the direction shown by the arrow) to adjust
the width of the head plates.
Figure 2 Adjustable feet of the table
Adjusting height and horizontal angle of head
plate
● Lift up the pull rod ①
in Figure 3 to adjust the
height of the head plate.
● Lift up the pull rod
②
in Figure 3 to adjust the
horizontal angle of the head plate.
The angle range is - 10° to 10°.
Figure 5
Drop operation
Lift the pull rod with one hand, and then press
down the bed section to achieve the effect of
drop pressure.(Figure 6)
Figure 3
①
②
②