Installation
Position the appliance and allow it to stand for two to three hours
before it is turned on for the first time to allow the system to
settle. Do not position next to any heat source e.g. cooker, boiler
or in direct sunlight etc.
Allow at least 10 cm of space at the top and 10 cm of space
on both sides of the appliance and between the back of the
appliance and the wall for adequate air circulation. The appliance
is not designed for recessed installation (“building in”).
Install on a good firm level surface, and any unevenness of the
floor should be corrected prior to installation, slight unevenness
can be overcome by adjusting the front feet.
NOTE:
If the appliance is positioned on a carpet, soft floor
covering you should readjust the front feet once the appliance
has had time to settle.
Use
• This appliance is designed to operate in ambient temperature
between 16°C and 38°C. If these temperatures are exceeded,
i.e. colder or warmer, the appliance will not operate correctly.
If the ambient temperatures are exceeded for long periods,
the temperature in the freezer section will rise above -18°C
and food spoilage may occur.
• Remove all packaging materials from the appliance.
Wash the inside of the cabinet with lukewarm water and
bicarbonate of soda (5ml to 0.5 liter of water). Dry the
appliance thoroughly.
• When you use the freezer for the first time or after
defrosting, set the thermostat control to the maximum
position for at least 2 hours before introducing food to be
stored, and then readjust to the normal position.
• If there is a power failure, do not open the door. Frozen
food should not be affected if the failure lasts for less than
12 hours. If the failure is longer, then the food should be
checked and either eaten immediately or cooked and then
re-frozen.
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat knob located
inside the fridge, towards the upper right-hand corner. (The
thermostat can be set to MIN (less cold), MED (Medium
temperature) and MAX (colder).)
39
38
GB
GB
Rear spacer
Screw the rear spacers at the rear of the unit�
screw
