Step #4
Spread open the flange of the
latch mounting post and slide it
down over the left side panel.
Slide the post up or down until
the support knob closes properly
into the recess on the post.
Once the latch post is aligned so
the gate closes properly fasten
the post to the side panel using
six (6) #10 x 1-1/4” screws.
Step #6
Close the gate and align the
latch bar by locking it into the
gate latch as shown. Secure the
latch bar to the gate with two (2)
#10 x 1-1/4” screws.
Step #7
Install the gate closer in the
indented portion provided
on the hinge post. Follow
the directions provided
with the gate closer package.
DO NOT
use the slide plate.
It is for metal/wood finish
wear and will not work with
our gravity hinge.
Step #5
Install the latch on the mounting
block located on the upper
portion of the latch using
four (4) #10 x 1-1/4” screws.
3
WARNING: GATE MUST BE LOCKED WHEN POOL IS NOT IN USE.
Note:
Spraying the gate hinges with a silicone spray will aid in the self-closing action.
The PES-G now includes a gate closer.
Mount the closer on the flat recessed are
on the hinge post (see diagram to left).
To adjust tension on the closer after
installation see detailed instructions on
closer package.
